How To Use An Auto Belay

Loading... 8378 view(due south)

How to Apply an Motorcar Belay: Step by Stride Instructions

It'due south very easy to learn how to use an auto belay. The proper utilise of an motorcar belay is simple and straightforward. Equally with everything in climbing, it is important to avoid learning bad habits and build the right ones from the start. Nearly motorcar belay accidents occur due to human error when an experienced climber becomes complacent and forgets to prune in. Obviously, an auto belay won't work if you lot're not attached to it.

The best mode to avoid complacency when climbing is to focus on the process rather than the outcome. Establish a routine that includes all the proper safe checks. Do not get straight to the finish goal without double-checking everything simply considering you lot're confident that you did information technology right because you've done it a million times earlier. Yous take a routine safety check when y'all're using an auto belay just like yous accept an established routine for your safety check with your belay partner.

If y'all've never used an auto belay earlier, you should alarm the climbing wall staff that you take not been trained in the proper utilize of an auto belay. They volition instruct you in how to safely use the auto belay device in their specific setup. The video and stride-past-step instructions on this page are created for the TRUBLUE Auto Belay.

How to Prepare For Your Car Belay Climb

1. Cheque your harness

Check the climbing harness is correctly fitted and tightened
If your harness has a standard buckle, recollect to double information technology back
Different types of harnesses require different safety checks. This is not a complete guide to checking your harness. You are responsible for beingness familiar with your harness and how information technology should be worn.

two. Check Automobile Belay performance by pulling out a brusk section and allowing it to retract

If the Machine Belay line fails to retract, exercise not clip into the Auto Belay and request assist

3. Open the triple activeness, auto-locking carabiner

The carabiner is opened by sliding the gate down, rotating the gate'south neckband and pushing the gate open towards the centre of the carabiner. Be careful to not let go of the carabiner or else the entire webbing will retract into the device.

4. Connect the carabiner to the belay loop on the harness with the gate facing away from the user

As previously mentioned all harnesses are unlike. For nigh harnesses, the correct connexion signal is the belay loop. Do not prune the carabiner into multiple difficult points. This will cause tri-beam loading. The carabiner is designed to work all-time when force is exerted on it in 2 directions. If three directions of force are exerted on the carabiner it will increment the chance that the carabiner will neglect.

5. Check that the carabiner is properly locked

Allow the latch to snap close, ensuring the collar has rotated dorsum and is locked. Ensure that no clothing, webbing or other objects are obstructing the gate or latch.

half dozen. Ensure the carabiner is just loaded along its vertical direction

7. Double check your carabiner is fastened to the proper point on your harness

8. Double check that the carabiner is locked

Tips for Proper Performance While Climbing

Never climb alongside or in a higher place the Auto Belay.
Do non climb faster than the auto belay is able to retract.
If y'all require faster retraction speeds, you should consider using the TRUBLUE Speed Machine Belay.
Do non climb outside the belay zone.
Most climbing gyms will mark the auto belay boundaries. Practice not climb a route exterior the auto belay boundary.
A typical belay lane is shown in the picture beneath.

trublue auto belay climbing lane

Proper Operation While Descending

Do not start your descent from above the auto belay
Prior to descent, make sure that your descent path is clear from obstacles and other climbers
Ever descend anxiety first, using feet to fend off obstacles and ready for landing.
Reattach the carabiner to the belay gate or designated attachment indicate

How to Become an Auto Belay Pro

Now that you're familiar with the basic operation of an auto belay you tin take the side by side step toward condign an machine belay master. The TRUBLUE Auto Belay is a great training tool for edifice endurance and providing a fill-in for learning new skills. Make sure that yous're comfortable with the bones performance of an auto belay before moving on to more avant-garde skills and drills. This video has expert communication about using an automobile belay to build stone climbing endurance. This adjacent video will teach you how to atomic number 82 climb while using an auto belay as a fill-in. Now you're well on your fashion to being an auto belay pro. Climb hard, and stay condom!